Volkswagen Owners Club Forum banner
5K views 1 reply 1 participant last post by  shawn_tyra30 
#1 ·
Started 3 days ago. It will **** manually 1st to 2nd and 2nd to 3rd. then when i put it in Drive it just stays in 3rd, when I'm on the road it stays in 3rd even when i slow down and take off again, unless i do it manually , also reverse works. It shifts smooth manually through the gears. two days again i took it to advance auto and had it scanned and it showed a Vacuum hose leak and a speed shaft sensors (G38) so i ordered the G38 speed sensor and put on this morning and it still is in limp mode, i also could not find a vacuum leak.

I changed the trany fluid yesterday also.

Yes, the cheek engine light is on.

Would a G38 sensor make it go into limp mode?

Would a Vacuum leak make it go into limp mode?

Even if i put the new G38 sensor on do i need to go have the code cleared to make it work?

Please Help thanks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top