Volkswagen Owners Club Forum banner
5K views 2 replies 2 participants last post by  sam_gtigolf 
#1 ·
Anyone successfully enabled the needle sweep function via Vag Com on a 2009 VW Golf GTI, enabled it myself and it wouldn't work. Wondering if it could be because its an earlier Mk6?

Also what other VAG COM mods is there to do on a mk6 gti golf?

Thanks in advance


2009 Golf GTI 2.0, Tornado Red, Engine code: CCZB, Manual, RCD 510, Custom 2.5" Turbo back Sports Cat Exhaust System with 4" slash cut tips, Ram-Air Oversized Induction, 225/40/18 Goodyear Eagle F1 Asymmetric 3s, Monza Shadow Alloys, Ferrodo DS2500 pads, braided lines, Millers Nano-drive 5W-40
 
#2 ·
You need an "H" type cluster, it won't work on others.

It's called staging (VCDS):
Address 17 – Instruments
Adaptation 10
Select "Staging" from the drop down list
Select "Active" from the drop down list
Save the changes
Done!

VCDS will tell you if it is an H cluster or not, like "970H"
There is also a sticker on the bottom of the cluster that will also have "970H"
The number has to end with an "H", or no staging.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top